Bay Networks BayStack ARN Routers none Servisní příručka Strana 36

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 156
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 35
Installing and Operating BayStack ARN Routers
1-6 114200 Rev. A
Rack-Mounting the ARN
For this procedure, you need
Four #10 cagenut screws and washers (shipped with the ARN)
Two flange brackets and eight #6 flathead screws (shipped with the ARN)
A Phillips screwdriver
An electronic enclosure rack
To rack-mount the ARN:
1. Attach a flange bracket to both sides of the ARN.
On each side of the chassis:
a. Align the holes in the longer end of the flange bracket with the
mounting holes near the front panel of the ARN (F
igure 1-2).
b. Insert a #6 flathead screw through each hole and into the ARN.
c. Tighten the four screws with a Phillips screwdriver.
Note: If the rack does not have threaded rail holes, you must supply and attach
four cagenuts.
Zobrazit stránku 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 155 156

Komentáře k této Příručce

Žádné komentáře