Bay Networks BayStack ARN Routers none Servisní příručka Strana 94

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 152
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 93
Installing and Operating BayStack ARN/DC Routers
A-2
116273-B Rev 00
Using the ifconfig Command
A router interface cannot communicate in an IP network without an IP address.
Because an ARN/DC netboots over one of its serial, 56/64K DSU/CSU or
Ethernet links, the netboot interface must have a valid IP address.
You use the interface configuration command
ifconfig
to do the following:
Configure the router’s initial IP interface to the network. (The initial IP
interface should be a serial interface if you are using EZ-Install.) You also use
the same procedure to configure other serial interfaces for the netbooting
procedure.
Configure Ethernet interfaces for the netbooting procedure.
Enable or disable netbooting on an interface.
Configuring an IP Serial or DSU/CSU Interface for Netbooting
Configure a serial or 56/64K DSU/CSU (COM) interface to the IP network using
the following interface configuration command:
ifconfig
[
synchronous options
]
<interface>
[
<IP address> <subnet mask>
[
<next
hop address>
]]
The synchronous options variable indicates some combination of the following
settings:
[
-d
|
-r
[
56
|
64
]
|
-fr
[
-annexd
|
-lmi
|
-annexa
]
|
-int_clk
]
Note:
Make sure to separate command options with spaces.
Zobrazit stránku 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 151 152

Komentáře k této Příručce

Žádné komentáře