Bay Networks 4000 Instalační příručka stáhnout pdf (Strana 124)

Remote Annex 4000 Hardware Installation Guide

Chapter 4 Troubleshooting Procedures

4-18

A PC host running the UNIX operating system has both the erpcd

and slipd daemons (provided with the distribution and installed in

/etc) running in the background on the PC. Set the Remote Annex

4000 and the erpcd on the load host into test mode:

1 For erpcd on the load server host, as superuser, kill the erpcd

program and restart it using the –D option:

# /usr/annex/erpcd -D5

2 For the Remote Annex 4000, hold down the Test button until the

Power LED blinks rapidly, then release the Test button and press it

again within 3 seconds. Then enter:

# boot -v

Another Remote Annex 4000

When troubleshooting a Remote Annex 4000 configured as a load

server host:

1 Use the CLI telnet command to access the unit and verify that it is up

and running.

2 Communicate with the unit on the Ethernet using the superuser CLI

ping command.

3 Verify the unit’s conﬁguration using the na utility.

The Remote Annex Administrator’s Guide for UNIX provides more

information on these commands.

A Remote Annex 4000 that has been reconfigured as a load server

host, but not rebooted, cannot boot another Remote Annex 4000 on

the network. Rebooting the Remote Annex 4000 load server host

ensures that the parameters are set.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 161 162

Žádné komentáře

Bay Networks 4000 Instalační příručka Strana 124