Bay Networks Remote Annex Instalační příručka stáhnout pdf (Strana 81)

3-15

Chapter 3 ROM Monitor Commands

Nortel Networks 5399 Access Switch Hardware Installation Guide

erase

The erase command erases the contents of non-volatile memory

(EEPROMmemory).ErasingEEPROMrestoresallparameterstofactory

default values. The syntax is:

erase

The erase command prompts for confirmation before erasing the

non-volatile (EEPROM) memory.

The

erase command display looks like this:

The erase command does not erase the Ethernet address.

Since the erase command erases the IP address, you may need

to use the addr command to re-enter the Remote Access

Concentrator’s IP address before reloading any software (if you

are using BOOTP or RARP, you should not set the IP address).

monitor:: erase

Erase all non-volatile EEPROM memory? (y/n) [n]:: y

Erasing <65504 or 8160 bytes> of non-volatile memory.

Please wait...

16K->|Data 0x0

.........................................

Initialized checksum record installed

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 125 126

Žádné komentáře

Bay Networks Remote Annex Instalační příručka Strana 81